D-Link DGS-1510 Series Reference Manual page 449

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Not applicable.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the NTP status.
Example
This example shows how to display NTP status.
Switch# show ntp status
Leap Indicator:
Stratum:
Precision:
Root Distance:
Root Dispersion:
Reference ID:
Reference Time:
System Flags:
Jitter:
Stability:
Auth Delay:
Switch#
Display Parameters
Remote
Local
Our mode
Peer mode
Leap Indicator
Stratum
Precision
Root Distance
Root Dispersion
Reference ID
Reference Time
System Flags
Jitter
Stability
Unsynchronized
16
-8
0.00000 s
0.10680 s
[INIT]
00000000.00000000 Thu, Feb
Auth Monitor NTP Kernel Stats
0.000000 s
0.000 ppm
0.000000 s
The IP address of the peer.
The IP address of the Switch.
Our mode relative to the peer. This field can display the following
modes: active, passive, client, server, bdcast, and bdcastclient.
The peer's mode relative to us.
Synchronized: The Switch is synchronized to an NTP peer.
Unsynchronized: The Switch is not synchronized to any NTP peer.
Stratum of the Switch.
Precision value.
The total roundtrip delay to the primary reference clock.
The dispersion of the root path.
The IP address of the peer that the Switch is synchronized to.
Reference time stamp.
Auth: Requires authentication to configure.
Monitor: Enables the monitor.
NTP: The clock discipline is enabled.
Kernel: The kernel support is enabled.
Stats: System status control.
System jitter.
Frequency stability (wander) (s/s).
446
7 2036 6:28:16.00000