D-Link DGS-1510 Series Reference Manual page 206

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for the physical port interface configuration.
A user can use this command to enable or disable optical transceiver monitoring function for an SFP
port. When the monitoring function is enabled, an alarm event occurs when the parameters being
monitored go higher than the high alarm threshold or go lower than the low alarm threshold. A
warning event occurs when the parameters being monitored go higher than the high warning
threshold or go lower than the low warning threshold.
When an SFP with transceiver monitoring capability is plugged into a port but the transceiver
monitoring function of the port is disabled, the system will not detect the SFP's abnormal status but
the user can still check the current status by showing the interface transceiver command.
Example
This example shows how to enable transceiver monitoring on interface eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# transceiver-monitoring enable
Switch(config-if)#
22-6 transceiver-monitoring rx-power
This command is used to configure the thresholds of the input power for the specified port. Use the no
form of this command to remove the configuration.
transceiver-monitoring rx-power INTERFACE-ID {high | low} {alarm | warning} {mwatt
VALUE | dbm VALUE}
no transceiver-monitoring rx-power INTERFACE-ID {high | low} {alarm | warning}
Parameters
INTERFACE ID
high
low
alarm
warning
mwatt VALUE
dbm VALUE
Default
None.
Command Mode
Specifies the interface to modify.
Specifies that when the operating parameter rises above the
highest threshold, it indicates an abnormal status.
Specifies that when the operating parameter falls below the low
threshold this value, it indicates an abnormal status.
Specifies to configure the high and low threshold value condition.
Specifies to configure the high and low warning threshold
conditions.
Specifies the power threshold value in milliwatts. This value must be
between 0 and 6.5535.
Specifies the power threshold value in dBm. This value must be
between -40 and 8.1647.
203