D-Link DGS-1510 Series Reference Manual page 285

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
interface
forbidden interface
INTERFACE-ID
,
-
Default
No IGMP snooping multicast router port is configured.
Auto-learning is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. To specify a multicast router port,
the valid interface can be a physical port or a port-channel. The specified multicast router port must be
member port of the configured VLAN. A multicast router port can be either dynamic learned or
statically configured. With the dynamic learning, the IGMP snooping entity will learn IGMP, PIM, or
DVMRP packet to identify a multicast router port.
Example
This example shows how to add an IGMP snooping static multicast router port for VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping mrouter interface eth4/0/1
Switch(config-vlan)#
33-6 ip igmp snooping proxy-reporting
This command is used to enable the proxy-reporting function. Use the no form of this command to
disable the proxy-reporting function.
ip igmp snooping proxy-reporting [source IP-ADDRESS]
no ip igmp snooping proxy-reporting
Parameters
IP-ADDRESS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Specifies a static multicast router port.
Specifies a port that cannot be multicast router port.
(Optional) Specifies an interface or an interface list. The interface
can be a physical interface or a port-channel.
(Optional) Specifies a series of interfaces, or a separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
(Optional) Specifies the source IP of proxy reporting. The default
value is zero IP.
282