D-Link DGS-1510 Series Reference Manual page 538

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the SSH connections' status on the Switch.
Example
This example shows how to display SSH connections' information.
Switch# show ssh
SID Ver. Cipher
--- --- --------------------------- ---------------- -------------------------
0 V2 3des-cbc/sha1-96
1 V2 3des-cbc/hmac-sha1
Total Entries: 2
Switch#
Display Parameters
SID
Ver
Cipher
Userid
Client IP Address
60-9 ssh user authentication-method
This command is used to configure the SSH authentication method for a user account. Use the no
form of this command to restore the default authentication method.
ssh user NAME authentication-method {password | publickey URL | hostbased URL host-
name HOSTNAME [IP-ADDRESS | IPV6-ADDRESS]}
no ssh user NAME authentication-method
Parameters
user NAME
password
publickey URL
Userid
zhang3
lee4567890123456 2000::243
A unique number that identifies the SSH session.
Indicates the SSH version of this session.
The cryptographic / Hashed Message Authentication Code (HMAC)
algorithm that the SSH client is using.
The login username of the session.
The client IP address for this established SSH session.
Specifies the username to configure the authentication type. The
user must be an existing local account. The length of the username
is limited to a maximum of 32 characters.
Specifies to use the password authentication method for this user
account. This is the default authentication method.
Specifies to use the public key authentication method for this user
535
Client IP Address
192.168.0.100