D-Link DGS-1510 Series Reference Manual page 237

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# errdisable recovery cause psecure-violation interval 200
Switch(config)#
This example shows how to enable the auto-recovery option for port security violations.
Switch# configure terminal
Switch(config)# errdisable recovery cause psecurity-violation
Switch(config)#
27-2 show errdisable recovery
This command is used to display the error-disable recovery timer related settings.
show errdisable recovery
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to verify the settings of the error disable recovery timer.
Example
This example shows how to display the settings of the error disable recovery timer.
Switch(config)#show errdisable recovery
ErrDisable Cause
-------------------------------------
Port Security
Storm Control
BPDU Attack Protection
Dynamic ARP Inspection
DHCP Snooping
Loop Detection
Interfaces that will be recovered at the next timeout:
Interface
---------
eth1/0/7
eth2/0/3
eth2/0/5
Switch#
Errdisable Cause
-------------------------------------
BPDU Attack Protection
Loop Detection
Loop Detection
State
-----------
enabled
enabled
disabled 120 seconds
enabled 120 seconds
enabled
enabled
Time left(sec)
--------------
infinite
45
45
234
Interval
-------------
120 seconds
120 seconds
120 seconds
120 seconds