D-Link DGS-1510 Series Reference Manual page 343

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to enable the JWAC Quarantine server function.
Switch# configure terminal
Switch(config)# jwac quarantine-server monitor
Switch(config)#
40-9 jwac quarantine-server timeout
This command is used to set the JWAC Quarantine server timeout period. Use the no form of this
command to revert to the default setting.
jwac quarantine-server timeout SECONDS
no jwac quarantine-server timeout SECONDS
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the Quarantine server monitor is enabled, the JWAC switch will periodically check if the
Quarantine server works. If the switch does not receive any response from the Quarantine server
during the configured error timeout period, the switch will regard it as working improperly.
Example
This example shows how to configure the JWAC Quarantine server error timeout period to 60
seconds.
Switch# configure terminal
Switch(config)# jwac quarantine-server timeout 60
Switch(config)#
40-10 jwac redirect
This command is used to enable the JWAC redirect function or configure the redirect destination and
delay time. Use the no form of this command to disable the JWAC redirect or reset parameters to the
default settings.
jwac redirect [destination {quarantine-server | jwac-login-page} | delay-time SECONDS]
no jwac redirect [destination | delay-time]
Parameters
destination
Specifies the timeout period. The range is from 5 to 300 seconds.
(Optional) Specifies the destination to which the unauthenticated
host will be redirected to.
340