D-Link DGS-1510 Series Reference Manual page 448

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Leap
RefID
RootDistance
RootDispersion
PPoll
HPoll
KeyID
Version
Association
Reach
Unreach
Flash
Timer
Flags
Reference Timestamp
Originate Timestamp
Receive Timestamp
Transmit Timestamp
Filter Delay
Filter Offset
Filter Order
Offset
Delay
Error Bound
Filter Error
St
Poll
Reach
Delay
Offset
Disp
51-15 show ntp status
This command is used to display the NTP status.
show ntp status
Parameters
None.
Default
Leap indicator. The value is from 0 to 3.
The IP address of the machine peer is synchronized to.
The total roundtrip delay to the primary reference clock.
The total root dispersion to the primary reference clock.
The peer poll exponent.
The host poll exponent.
Authentication key ID.
The NTP version that the peer is using.
The Association ID.
Peer reaching ability.
Unreached counter.
Flash status word for diagnosing problems.
The peer timer in seconds.
The peer flags.
The time that the system clock was last set or corrected.
The time that the request departed for the server at the client.
The time that the request arrived from the client at the server.
The time that replied to the client at the server.
Round-trip delay of each sample in milliseconds.
Clock offset of each sample in milliseconds.
Filter order of each sample.
Offset of the peer clock relative to our clock.
Round-trip delay to the peer.
Peer dispersion.
Approximate error of each sample.
Stratum of the peer.
Polling interval in seconds.
Peer reaching ability.
Round-trip delay to peer in milliseconds.
Relative time of peer clock to local clock in milliseconds.
Dispersion.
445