D-Link DGS-1510 Series Reference Manual page 328

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
38-4 ipv6 snooping attach-policy
This command is used to apply an IPv6 snooping policy to a specified VLAN. Use the no form of this
command to remove the binding.
ipv6 snooping policy attach-policy POLICY-NAME
no ipv6 snooping policy attach-policy
Parameters
POLICY-NAME
Default
None.
Command Mode
VLAN Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
After an IPv6 snooping policy has been created, use this command to apply the policy on a specific
VLAN.
Example
This example shows how to enable IPv6 snooping on VLAN 200.
Switch# configure terminal
Switch(config)# ipv6 snooping policy policy1
Switch(config-ipv6-snooping)# limit address-count 100
Switch(config-ipv6-snooping)# exit
Switch(config)# vlan 200
Switch(config-vlan)# ipv6 snooping attach-policy policy1
Switch(config-vlan)#
38-5 ipv6 snooping station-move deny
This command is used to deny the station move function for IPv6 snooping entries. Use the no form
of this command to revert to the default setting.
ipv6 snooping station-move deny
no ipv6 snooping station-move deny
Parameters
None.
Default
IPv6 snooping is permitting station moves.
Command Mode
Global Configuration Mode.
Command Default Level
Specifies the name of the snooping policy.
325