D-Link DGS-1510 Series Reference Manual page 406

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
ipv6 mld snooping minimum-version 2
no ipv6 mld snooping minimum-version
Parameters
None.
Default
No limit on minimum version.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. This setting only applies to filtering of
MLD membership reports.
Example
This example shows how to restrict all MLDv1 hosts to join VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping minimum-version 2
Switch(config-vlan)#
47-16 show ipv6 mld snooping
This command is used to display MLD snooping information on the Switch.
show ipv6 mld snooping [vlan VLAN-ID]
Parameters
vlan VLAN-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD snooping information for all VLANs on which MLD snooping are
enabled by not specifying specific VLAN.
Example
This example shows how to display MLD snooping configurations.
(Optional) Specifies the VLAN to be displayed.
403