D-Link DGS-1510 Series Reference Manual page 137

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to set a specified module's debug message output to debug to the buffer or the
local console. Use the show debug output command to display the module's string information. By
default, module debug message is output to the debug buffer. The module debug message will be
output when the module owned debug setting is enabled and the global mode debug enable
command is enabled.
Example
This example shows how to configure all the module's debug messages to output to the debug buffer.
Switch# debug output all buffer
Switch#
14-3 debug reboot on-error
This command is used to set the Switch to reboot when a fatal error occurs. Use the no form of this
command to set the Switch not to reboot when a fatal error occurs.
debug reboot on-error
no debug reboot on-error
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enable the Switch to reboot when a fatal error occurs.
Example
This example shows how to enable the Switch to reboot on fatal errors.
Switch(config)# debug reboot on-error
Switch(config)#
14-4 debug copy
This command is used to copy debug information to the destination filename.
debug copy SOURCE-URL DESTINATION-URL
debug copy SOURCE-URL tftp: //LOCATION/DESTINATION-URL
134