D-Link DGS-1510 Series Reference Manual page 657

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This command is used to add or remove the VLAN classification entry for a protocol group on a port.
Example
This example shows how to create a VLAN classification entry on eth1/0/1 to classify packets in
protocol group 10 to VLAN 3000.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# protocol-vlan profile 10 vlan 3000
Switch(config-if)#
75-15 show protocol-vlan
This command is used to display protocol groups.
show protocol-vlan {profile [PROFILE-ID [, | -]] | interface [INTERFACE-ID [, | -] ]}
Parameters
profile
PROFILE-ID
,
-
interface
INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display protocol groups.
Example
This example shows how to display the settings for VLAN classification based on the protocol group
on port eth1/0/1.
Specifies to display the protocol group.
(Optional) Specifies the protocol group to display.
(Optional) Specifies a series of protocol groups, or separate a range
of protocol groups from a previous range. No space is allowed
before and after the comma.
(Optional) Specifies a range of protocol groups. No space is allowed
before and after the hyphen.
Specifies to display protocol VLAN information of ports.
(Optional) Specifies the interface to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
654