D-Link DGS-1510 Series Reference Manual page 400

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
source IPV6-ADDRESS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration.
When the function proxy reporting is enabled, the received multiple MLD report or leave packets will
be integrated into one report before being sent to the router port. Proxy reporting source IP will be
used as source IP of the report, Zero IP address will be used when the proxy reporting source IP is
not set.
Example
This example shows how to enable MLD snooping proxy-reporting on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping proxy-reporting
Switch(config-vlan)#
47-7 ipv6 mld snooping querier
This command is used to enable the MLD snooping querier on the Switch. Use the no form of this
command to disable the MLD snooping querier function.
ipv6 mld snooping querier
no ipv6 mld snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. The interface must have IPv6
address assigned to start the querier.
If the system can play the querier role, the entity will listen for MLD query packets sent by other
devices. If MLD query message is received, the device with lower value of IPv6 address becomes the
querier.
Example
(Optional) Specifies the source IP address of proxy reporting.
397