Chrysler 2005 Crossfire SRT6 Service Manual page 488

5 - 322 BRAKES - ABS ELECTRICAL DIAGNOSTICS
ABS VERIFICATION TEST
ABS VERIFICATION TEST
1.
Turn the ignition off.
Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
With the DRB III , erase all Diagnostic Trouble Codes (DTCs) from ALL modules. Start the engine and allow it to
run for 2 minutes.
Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRB III , read DTCs from ALL modules.
CAUTION: Ensure braking capability is available before road testing.
Note: For sensor signal and pump motor faults, the CAB must sense all 4 wheels at 25 km/h (15 MPH)
before the CAB will extinguish the indicator lamp.
Road test the vehicle for a minimum of 5 minutes. Perform several antilock braking stops.
Again, with the DRB III , confirm that no DTCs are present and that all components are functioning properly.
If there are no DTCs present and all components are functioning properly, the repair is complete.
Are any DTCs present?
YES >> Repair is not complete, refer to appropriate symptom.
NO >> Repair is complete.
ZH