Chrysler 2005 Crossfire SRT6 Service Manual page 479

ZH
1351-YAW RATE/ACCELERATION SENSOR - UNDERVOLTAGE (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE YAW RATE/ACCELERATION SENSOR 5-VOLT SUPPLY CIRCUIT
With the ignition off.
Measure the resistance of the 5-Volt Supply circuit from the Yaw Rate/
Acceleration Sensor harness connector to the CAB harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the Yaw Rate/Acceleration Sensor 5-Volt Supply
circuit for an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 313
ANTILOCK BRAKE -