Chrysler 2005 Crossfire SRT6 Service Manual page 486

5 - 320 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1355-YAW RATE/ACCELERATION SENSOR - SHORT TO VOLTAGE (CONTINUED)
2.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE YAW RATE/ACCELERATION SENSOR
5-VOLT SUPPLY CIRCUIT
With the ignition off.
Disconnect the Controller Antilock Brake (CAB) harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the voltage of the Yaw Rate/Acceleration Sensor 5 Volt Sup-
ply circuit at the Yaw Rate/Acceleration Sensor harness connector.
Is the voltage above 5.0 volts?
Yes >> Repair the 5-Volt Supply circuit for a short to voltage.
Perform ABS VERIFICATION TEST.
No >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH