Chrysler 2005 Crossfire SRT6 Service Manual page 481

ZH
1352-YAW RATE/ACCELERATION SENSOR - OVERVOLTAGE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on.
• Set Condition: The Controller Antilock Brake (CAB) detects a Yaw Rate/Acceleration Sensor Overvoltage con-
dition.
ESP YAW RATE/LATERAL ACCELERATION SENSOR 5-VOLT SUPPLY CIRCUIT SHORT TO VOLTAGE
ESP YAW RATE/LATERAL ACCELERATION SENSOR
CONTROLLER ANTILOCK BRAKE (CAB)
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
MEASURE THE YAW RATE/ACCELERATION SENSOR 5 VOLT SUPPLY CIRCUIT
Turn the ignition off.
Disconnect the Yaw Rate/Acceleration Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Yaw Rate/Acceleration Sensor 5 Volt Sup-
ply circuit at the Yaw Rate/Acceleration Sensor harness connector.
Is the voltage above 5.0 volts?
Yes >> Go to 2
No >> Replace the Yaw Rate/Acceleration Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/LATERAL ACCELERATION SEN-
SOR - REMOVAL).
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 315
POSSIBLE CAUSES