Mep Cross-Check; Mep Cross-Check Enable - Dell S4810 Reference Manual

mep cross-check

Enable cross-checking for a MEP.
S4810
Syntax
mep cross-check mep-id
Parameters
mep-id
Defaults none
Command ECFM DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0

mep cross-check enable

Enable cross-checking.
S4810
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port
vlan-id
Defaults none
Command ECFM DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
802.1ag
Enter the MEP ID. The range is from 1 to 8191.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Down service with no VLAN association.
Enter the VLAN to apply the cross-check.
171