Send - Dell S4810 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
E-Series
Usage If there is a change in the configuration, FTOS prompts you to save the new
Information configuration. Or you can save your running configuration with the copy
running-config command. Use the conditional parameter if any configuration
changes made to the nvram, such as stack-group and fanout configurations, must
be saved.
Related
•
Commands

send

Send messages to one or all terminal line users.
S4810
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
*
line
console
vty
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
124
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
reset stack-unit — resets any designated stack member except the
management unit.
Enter the asterisk character * to send a message to all tty
lines.
Send a message to a specific line. The range is from 0 to 11.
Enter the keyword console to send a message to the
primary terminal line.
Enter the keyword vty to send a message to the virtual
terminal.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Control and Monitoring