Dell S4810 Reference Manual page 200

mac-address
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.4.2.1
Usage
Enter a supplicant's MAC address using the mac-address option to display CoS
Information
mapping information only for the specified supplicant.
You can display the CoS mapping information applied to traffic from authenticated
supplicants on 802.1X-enabled ports that are in Single-Hot, Multi-Host, and Multi-
Supplicant authentication modes.
Example
Dell#show dot1x cos-mapping interface gigabitethernet 2/21
802.1p CoS re-map table on Gi 2/21:
----------------------------------
Dot1p
0
1
2
3
4
5
6
7
200
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
(Optional) MAC address of an 802.1X-authenticated
supplicant.
EXEC
EXEC privilege
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Remapped Dot1p
7
6
5
4
3
2
1
0
802.1X