Ssh-Peer-Stack-Unit; Telnet - Dell S4810 Reference Manual

•

ssh-peer-stack-unit

Open an SSH connection to the peer stack-unit.
S4810
Syntax
ssh-peer-stack-unit [-l username]
Parameters
-l username
Defaults Not configured.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 8.3.11.1

telnet

Connect through Telnet to a server. The Telnet client and server in Dell Networking support IPv4 and
IPv6 connections. You can establish a Telnet session directly to the router or a connection can be
initiated from the router.
NOTE: The Telnet server and client are VRF-aware. Using the vrf parameter in this command, you
can make a Telnet server or client to listen to a specific VRF. This capability enables a Telent server
or client to look up the correct routing table and establish a connection.
Control and Monitoring
show processes memory (S-Series)
running processes.
(OPTIONAL) Enter the keyword -l then your user name. The
default is the user name associated with the terminal.
EXEC
EXEC Privilege
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the S-Series.
— displays the memory usage based on
155