Control And Monitoring; Asf-Mode - Dell S4810 Reference Manual

Control and Monitoring

This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP) as they apply to the following Dell Networking
S4810 platform.
NOTE: Starting in version 8.3.10.0, the enable xfp-power-updates command was deprecated
for the S4810. This command replaces the enable optic-info-update interval command to
update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).

asf-mode

Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
S4810
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
Parameters
unit-id
queue size
Defaults Not configured
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Control and Monitoring
Enter the stack member unit identifier of the stack member
to reset. The S4810 range is from 0 to 11.
NOTE: The S4810 commands accept Unit ID numbers
from 0 to 11, though S4810 supports stacking of up to six
units.
Enter the queue size of the stack member. The range is from
0 to 15.
Introduced on the S4820T.
4
91