Reload - Dell S4810 Reference Manual

Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2
seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
::
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
Dell#
Example (IPv6)
Dell#ping 100::1
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 100::1, timeout is 2 seconds:
!!!!!
Success rate is 100.0 percent (5/5), round-trip min/avg/max =
0/0/0 (ms)
Dell#

reload

Reboot Dell Networking Operating System (OS).
S4810
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Control and Monitoring
Reload if the condition is true. A configuration change to the
nvram requires a switch reload. To reload the switch, select
nvram-cfg-change.
Introduced on the S6000.
Introduced on the Z9000.
Added 'conditional' parameter.
Introduced on the S4820T.
Introduced on the Z9000.
123