Resequence Access-List - Dell S4810 Reference Manual

resequence access-list

Re-assign sequence numbers to entries of an existing access-list.
S4810
Syntax resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum Step-
to-Increment}
Parameters
ipv4 | ipv6 |
mac
access-list-
name
StartingSeqNu
m
Step-to-
Increment
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Access Control Lists (ACL)
Enter the keyword ipv4or mac to identify the access list type
to resequence.
Enter the name of a configured IP access list.
Enter the starting sequence number to resequence. The
range is from 0 to 4294967290.
Enter the step to increment the sequence number. The
range is from 1 to 4294967290.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale (IPv6).
Introduced on the E-Series ExaScale (IPv4).
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
219