Cam-Acl-Vlan; Clear Line - Dell S4810 Reference Manual

cam-acl-vlan

Specify the number of VFP blocks allocated to OpenFlow.
S4810
Syntax
cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow
vlaniscsi
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Version
8.3.19.0
Usage
Reboot the switch after changing the parameter values for changes to take effect.
Information
For platform-specific instructions about using this command, refer to the SDN
chapter in the Dell Networking OS Configuration Guide.

clear line

Reset a terminal line.
S4810
Syntax
clear line {line-number | aux 0 | console 0 | vty number}
Parameters
line-number
94
Enter the number 1 to allocate VFP blocks and enable
OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.
Introduced on S4810.
Introduced on the S4820T.
Enter a number for one of the 12 terminal lines on the
system. The range is from 0 to 11.
Control and Monitoring