Dell S4810 Reference Manual page 160

Version 7.4.1.0
E-Series
Usage When you enter the traceroute command without specifying an IP address
Information
(Extended Traceroute), you are prompted for a target and source IP address,
timeout (in seconds) (default is 5), a probe count (default is 3), minimum TTL
(default is 1), maximum TTL (default is 30), and port number (default is 33434). To
keep the default setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum
hop count (default is 64).
Example (IPv4)
Dell#traceroute www.Dell Networking.com
Translating "www.Dell Networking.com"...domain server
(10.11.0.1) [OK]
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to www.Dell Networking.com (10.11.84.18),
30 hops max, 40 byte packets
-----------------------------------------------
TTL Hostname
1
2
ms 001.000 ms 001.000 ms
3
000.000 ms 000.000 ms
4
ms 000.000 ms
FTOS#
Example (IPv6)
Dell#traceroute 100::1
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to 100::1, 64 hops max, 60 byte packets
-----------------------------------------------
Hops Hostname Probe1
1
FTOS#traceroute 3ffe:501:ffff:100:201:e8ff:fe00:4c8b
Type Ctrl-C to abort.
-----------------------------------------------
Tracing the route to 3ffe:501:ffff:100:201:e8ff:fe00:4c8b,
64 hops max, 60 byte packets
-----------------------------------------------
Hops Hostname
1
Dell#
160
Added support for IPv6 address on the E-Series.
Original command.
Probe1
10.11.199.190 001.000 ms 001.000 ms 002.000 ms
gwegress-sjc-02.Dell Networking.com (10.11.30.126) 005.000
fw-sjc-01.Dell Networking.com (10.11.127.254) 000.000 ms
www.Dell Networking.com (10.11.84.18) 000.000 ms 000.000
100::1 000.000 ms 000.000 ms 000.000 ms
Probe1
3ffe:501:ffff:100:201:e8ff:fe00:4c8b
000.000 ms 000.000 ms 000.000 ms
Probe2 Probe3
Probe2 Probe3
Probe2 Probe3
Control and Monitoring