Honda 2004 Odyssey Service Manual page 489

PGM-FI System
Injector Replacement (cont'd)
7. Slide new cushion rings (A) onto the injectors (B).
C
A
B
E
8. Coat new O-rings (C) with clean engine oil, and put them on the injectors.
9. Insert the injectors into the fuel rails (D).
10. Coat new seal rings (E) with clean engine oil, and press them into the intake manifold.
11. Install the fuel injectors and fuel rails into the intake manifold.
12. Install and tighten the retainer bolts.
13. Install the connectors on the injectors.
14. Install the intake manifold and the intake manifold covers (see page 9-7).
15. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for approximately 2
seconds, the fuel pressure in the fuel line rises. Repeat this two or three times, then check for fuel leakage.
11-180
D