Optional) Configuring The Inactive Aging Time For The Original Traffic; Optional) Configuring The Active Aging Time For The Original Traffic; Checking The Configuration - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
----End
5.3.6 (Optional) Configuring the Inactive Aging Time for the
Original Traffic
Context
After the inactive aging time is set for the original traffic, the SPU considers that the original
traffic is aged if the SPU does not receive any data packet from the original traffic within the
inactive aging time. Then the SPU stops the statistics collection and sends the result to the NSC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream timeout inactive inactive-interval
The inactive aging time is set for the original traffic.
By default, the inactive aging time of the original traffic is 30s.
----End
5.3.7 (Optional) Configuring the Active Aging Time for the Original
Traffic
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream timeout active active-interval
The active aging time is set for the original traffic.
By default, the active aging time of the original traffic is 30 minutes.
----End

5.3.8 Checking the Configuration

Prerequisites
The NetStream configuration is complete.
Issue 01 (2012-03-15)
NOTE
If multiple aging conditions are configured on the SPU, the traffic ages when it meets any condition.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
152