Optional) Setting The Lacp Priority Of The System; Optional) Limiting The Number Of Active Interfaces - Huawei Quidway S9300 Configuration Manual

2 Link Aggregation Configuration
----End

2.5.4 (Optional) Setting the LACP Priority of the System

Context
Do as follows on the S9300 where you need to set the LACP priority of the system.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
lacp priority priority
The system LACP priority of the S9300 is set.
The smaller the LACP priority value of the system is, the higher the priority is. By default, the
LACP priority of the system is 32768.
The end of a smaller priority value functions as the Actor. If the two ends have the same priority,
the end with a smaller MAC address functions as the Actor.
----End

2.5.5 (Optional) Limiting the Number of Active Interfaces

Context
Do as follows on the S9300 where you need to limit the number of active interfaces.
Procedure
l
2-14
Ethernet interfaces on different LPUs can be added to the same Eth-Trunk.
–
The peer interface directly connected to the Eth-Trunk on the local end must also be
–
added to an Eth-Trunk; otherwise, the two ends cannot communicate.
Setting the upper threshold of the number of active interfaces
1. Run:
system-view
The system view is displayed.
2. Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
3. Run:
max bandwidth-affected-linknumber link-number
The upper threshold of the number of active interfaces is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)