Setting Distance Adjustment Between The Registration Mark - GRAPHTEC CE6000 SERIES User Manual

Setting Distance Adjustment Between the Registration Mark

It will adjust the cutting if the distance between the registration marks are different from the original value on
the data using the ratio calculated from the difference. This is called distance adjustment between registration
marks.
There are following 3 modes for adjustment between registration marks.
User : Original value on the data against the distance of scanned registration marks are entered
manually to perform adjustment.
Custom : If the distance between the registration mark are to be output in factors of 5, 10, or 50 mm, set
that unit as the "CUSTOM UNIT", and automatically adjust the distance between the registration
marks. For example, set the "CUSTOM UNIT" to 5 mm, and if the distance between the
scanned registration marks were 312 mm, it will be rounded off to the closest 5 mm, and the
adjustment will be performed so the ideal distance will be 310 mm.
Standard : Depending on the settings of the distance between the registration marks (see "Setting Mark
Distance"
of the distance between scanned registration mark will be rounded off to the nearest units
selected, which will be used as the original value on the data to perform the adjustment.
Please use the proper parameters for each length:
Over 1 m
Over 50 cm : 10 mm
Under 50 cm : 5 mm
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
3
Press the POSITION ( ) key.
ARMS SETTING screen (2/4) is displayed.
), either 5, 10, or 50 mm will be selected as the unit automatically. Values
P.5-14
: 50 mm
Supplement
Perform the settings in Normal mode.
5-16