It will copy in following order when COORDINATE AXES ROTATION is set.
Create one data you want to copy.
Cutting data is stored in the buffer memory.
Press the POSITION (
to the position to copy.
Press the [COPY] key.
COPY MODE screen is displayed.
Press the  key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE setting screen is displayed.
Press the  key (OFF).
Confirm the settings and return to the COPY MODE screen.
) key and move the tool carriage
When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
If too much data is sent from the buffer
memory, "1 copy in the Copy mode buffer!"
will be displayed.
If the data to be copied is larger than the
cutting area, "Cannot copy, the valid area is
too small" will be displayed.