Press the POSITION (
Confirm the setting and press the [ENTER] key (SET).
Adjustment by scanning the registration mark is completed, and it will
return to default screen.
This section describes the operation to adjust with registration
mark scan by moving to registration mark manually after setting the
ARMS mode and POINTS.
Press the  key (MANUAL READ MARKS) in the ARMS
SETTING screen (1/4).
Following message is displayed.
) key and increase or decrease the
Measured distance is displayed in the top
line in the DISTANCE input screen. Input
value (initially same as measured value) is
displayed under that.
If the input value is not changed, it will assume
that there is no difference between measured
distance and the distance in the data.
Digits of settings can be changed by pressing
the [FAST] key.
It will return to ARMS setting screen (1/4)
without changing the settings when you
press the POSITION ( ) key (CANCEL).
Distance input screen for point 3 is displayed
if it is set to 3POINTS or more, so repeat
steps 4 and 5 to set.
See "Adjust Automatically"
are moving automatically to registration mark
Press the  key (ARMS) in the MENU screen
if it is not ARMS SETTING screen.