Changing The Hold-Down Force - GRAPHTEC CE6000 SERIES User Manual

Changing the Hold-down Force

The CE6000-120 requires the center push roller hold-down force to be set based on the media's width and
material type in order to keep the media in place. (This only applies to the CE6000-120)
Switching
(1) Lower the media set lever to raise the push rollers.
(2) Use the push roller hold-down force switching lever on the back of the push roller to adjust the center push
roller's hold-down force. It can be set to normal or Weak (OFF).
(3) When the push roller hold-down force switching lever is up, it is in Normal mode. When it is down, it's Weak
(OFF).
Hold-down force: Normal
CAUTION
Hold-down force can not be switched for side push rollers.
Supplement
Low (OFF) of hold-down force is the standard setting for cutting thin film like car film.
Switch the hold-down force as necessary for different types of media.
It is recommended that when the hold-down force is set to Low (Off), you set the Enabling/Disabling the Push Roller Sensors
to "INSIDE DISABLED", and then move the push roller to a position with no grit roller.
P.10-5
Lever
Hold-down force: Low (OFF)
Lever
2-21