GRAPHTEC CE6000 SERIES User Manual page 37

3
Pulled from the front, the roll media should be long enough
so that its tip completely covers the sensor. If you pull it too
long, wind the roll and adjust the length.
Push roller
4
Position the media and the push rollers to correspond with
the width of the media.
The push rollers push down on either side of the media. Use
the grit roller position guide to make sure the push rollers are
set on top of the grit rollers.
Push roller
Media
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of
the media.
15 mm
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of
the media.
5 mm
Media sensor
Grit roller
Grit roller position guide
Push roller
Media sensor
Push roller
15 mm
Media
Push roller
5 mm
Media
Supplement
The media must always be positioned over
the media sensor.
See "2.4 Aligning the Push Rollers"
about the position of the push rollers.
2-7
P.2-19