GRAPHTEC CE6000 SERIES User Manual page 138

6
Press the [1] key (SCAN).
Following message is displayed.
7
Press the POSITION (
to the area to start scanning of the registration mark.
Registration mark scan area
Align the tool to this area
8
Confirm the position of the tool, and if it is OK, press the
[ENTER] key.
Registration mark is scanned, and sensor level is adjusted. It will return
to ARMS SETTING screen (3/4) once the adjustment is completed.
9
Press the [PAUSE/MENU] key.
It will return to default screen.
) key and move the tool carriage
5-21
Supplement
It will return to ARMS SETTING screen (3/4)
after setting the sensor level to default when
you press the [2] key (DEFAULT).
Supplement
The tool carriage will move faster when the
[FAST] key is pressed simultaneously with the
POSITION key.
Supplement
It will return to ARMS SETTING screen (3/4)
without changing the settings when you
press the [4] key (CANCEL).
It may not scan correctly even after the
adjustment depending on the condition of
the media. See "Manual Position Adjust"
if the detection does not complete
P.6-3
properly.