Adjust With 3Points - GRAPHTEC CE6000 SERIES User Manual

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

Adjust with 3POINTS

3POINTS adjustment will scan 3 registration marks as shown below, where the adjustment is done measuring
the tilting of the X and Y axes and the distance between the registration marks (horizontal and vertical
directions). This adjustment is called 2 axis adjustment (tilt adjustment).
If the loaded media is tilted as shown below, position of the scanned registration mark is shifted from the position
where it should be. Tilt and distance can be adjusted by comparing these coordinate values.
Difference in X
Difference in X
Original registration
mark position
Difference in Y
Operation
1
Load the media with registration marks (3POINTS) plotted.
2
Set the MARK SCAN MODE to ARMS, and POINTS to
2POINTS.
Setting MARK SCAN Mode and Numbers
P.5-7
3
Set the shape and size of the registration mark, mark
distance, distance adjust mode, offset, paper-weight, sensor
level, scan position adjustment, etc., as needed.
Setting Shape (Pattern) of Registration Mark
P.5-11
Setting Registration Mark Size
P.5-12
Setting Mark Distance
P.5-14
Setting Distance Adjustment Between the
P.5-16
Registration Mark
Setting Offset Between the Registration Mark and
P.5-18
Cutting Origin Points
Adjusting the Sensor Level
P.5-20
Manually Adjusting the Sensor Level (Threshold
P.5-22
Value)
Setting Paper-Weight
P.7-17
Original registration mark position
Tilt
First registration mark
Tilt
Third registration
mark
Second registration mark
Difference in Y
5-37
Supplement
See "Loading Media (Paper or Marking Film)"
for loading the media.
P.2-5
Supplement
It is not necessary to set the MARK DISTANCE
when it is adjusted manually.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents