Settings For Cutting; Setting Cutting Area - GRAPHTEC CE6000 SERIES User Manual

4.1

Settings for Cutting

Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.

Setting Cutting Area

Origin point will be set at lower left of the AREA once the AREA is
set. It is possible to set the origin point at the center when the HPGL
is selected.
Move the origin point to change the cutting position.
It will only cut within
this range
Origin
point
Operation
1
Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS setting screen (1/2) is displayed.
3
Press the POSITION ( ) key.
AREA PARAMETERS setting screen (2/2) is displayed.
Upper right set
position
Image already cut
Supplement
See "Setting the Origin Point"
about the moving the origin point.
See "Setting Origin Point When HP-GL is
Set"
HPGL command.
Supplement
Perform the settings in Normal mode.
See "How to Use Control Panel"
for READY status.
4-2
P.3-7
for setting the origin point with
P.3-9
P.2-24