3.5
Stop Cutting
It will stop cutting when the [PAUSE/MENU] key is pressed while cutting. Operation selection menu is displayed
on the screen of the control panel while it is stopped. It is possible to choose either to continue or stop the
operation.
It is also possible to exchange or reset the media while it is stopped.
Pause and Resume Cutting
Operation
1
Press the [PAUSE/MENU] key.
Cutting will stop and following screen is displayed.
2
Perform necessary operation, such as exchanging the media.
3
Press the [1] key (CONTINUE JOB).
Cutting will start and the screen will resume to operation.
PROCESSING screen
(Normal mode)
PROCESSING screen
(Simple mode)
3-12
Supplement
There is no effect on the selection of media
type when the media set lever is moved up
and down while pausing the cutting. It is also
possible to exchange or reset the media.
Supplement
It will stop cutting by pressing [2] key (QUIT
JOB).
See "Stop Cutting"
P.3-13
.