Confirm the setting and press the POSITION ( ) key
Copy space will be selected, and it will return to COPY MODE screen.
Confirm the setting and press the [ENTER] key (SET).
"COPY MODY CHANGE MEDIA!" will be displayed on the screen.
Replace the media.
The plotter starts a copy immediately after replacing the media.
This operation's specified number of copies will be repeated.
In the case of suspension, press the POSITION ( ) key (QUIT
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or
set the media that is big enough to copy.
Cutting data is stored even if the media is
exchanged. It can be copied as many times
until the buffer memory is cleared. It can be
copied again after exchanging the media by
pressing [COPY] key.