Press the  key (OFFSET).
OFFSET setting screen is displayed.
Press the POSITION (
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
Press the [COND/TEST] key.
It will return to default screen.
) key and increase or decrease the
What is Offset
It will adjust the difference between the tip
of the blade in the plunger and the center of
the plunger. There are standard adjustment
values for each cutter blades. Fine
adjustment will be made to that standard
values here. (Adjustment will be made with
standard value as 0.)
It is not necessary to set the offset if "PEN",
was selected in the tool settings. (not
Guideline to Set Offset
* Set for the setting values not displayed in the
cutter blade type when cutting the media that
is hard to cut.
To return to continue the settings of other
tool condition number, return to step 3 by
pressing the  key.
1 to 45