6
Step
Press the
(PAUSE) key to cancel PAUSE mode.
CHECKPOINT
• This setting is retained in the memory even when the power is turned off.
• If the detection movement distance is set to 0 mm, the sensor continues detect-
• For 2-point alignment, the Y value is ignored.
• The medium will be ejected if the detection movement distance is set to a value
Setting the Registration-mark Pattern
The cutting plotter is capable of reading the following registration-mark patterns.
1
Step
Press the
(PAUSE) key to switch to PAUSE mode.
2
Step
Press the
(NEXT) or
A U T O R E G . M A R K
3
Step
Press the
(ENTER) key to display the Auto Reg. Mark submenu, and then press the
(PREV.) key until the following menu is displayed.
M A R K T Y P E
4
Step
Press the
(ENTER) key to display the registration-mark pattern setting.
M A R K T Y P E
Press the
or
key to select "1" or "2," and then press the
press the
(NEXT) or
ing between the registration marks without skipping until it detects the next mark.
greater than the medium length.
Registration-mark pattern 1
(PREV.) key until the following menu is displayed.
1
(PREV.) key.
Registration-mark pattern 2
(ENTER) key to confirm. To cancel,
4 – 12
X
Y
(NEXT) or