Setting the Distance Adjust
DISTANCE ADJUST value corrects any deviation in the length of cut or plotted line segments, which occurs
depending on the media being used. DISTANCE ADJUST value for the deviation is specified as a percentage of
the total distance. For example, a setting of +0.05% adjusts a distance of 2 m (2,000 mm) by 2,000 x 0.05% = 1
mm, making 2,001 mm. DISTANCE ADJUST can be specified for each CONDITION No.
This setting will be saved even if the power is shut off.
Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
Press the POSITION ( ) key.
CONDITION setting screen (3/3) is displayed.
Press the  key (DISTANCE ADJUST).
DISTANCE ADJUST setting screen is displayed.
Press the POSITION (
Press the  key (ON).
DISTANCE ADJUST becomes on and  key (X) and  key (Y)
) key and select the CONDITION
Perform the settings in Normal mode.