Setting The Tool - GRAPHTEC CE6000 SERIES User Manual

Setting the Tool

Set the type and offset value of the tool that is used in each of the tool condition numbers.
Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
3
Press the [1] key.
CONDITION No. selection screen is displayed.
* Display may vary depending on the selected condition number.
4
Press the POSITION (
the Tool/Offset you wish to change.
5
Confirm the setting and press the POSITION ( ) key
(PREVIOUS) .
CONDITION No. will get set and return to TOOL setting screen.
6
Press the POSITION (
) keys to select the Condition No. of
) key, and set the tool.
2-38
Supplement
Perform the settings in Normal mode.
In Simple mode, CB09U is locked.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION ( ) key (CANCEL).
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION ( ) key (CANCEL) .
Tools that can be selected are as following:
CB09U, CB15U, CB15U, OTHER,
CB09U-K60 PEN