Download Print this page

GRAPHTEC CE5000-60 User Manual: Setting The Registration-mark Distance Adjustment

Cutting plotter.
Hide thumbs

Advertisement

5
Step
Use the
or
key to set the value within the range "5 mm" to "20 mm," and then press the
(ENTER) key to confirm. To cancel the selection, press the
6
Step
Press the
(PAUSE) key to cancel PAUSE mode.

Setting the Registration-Mark Distance Adjustment

M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
This adjusts the distance between registration marks automatically, rounding up or
down to the nearest 5 mm, 10 mm, or 50 mm as specified. If STD. (Standard) is
selected, the distance is automatically rounded up or down to the nearest 5 mm,
10 mm, or 50 mm depending on the distance between the marks.
Up to 50 cm: 5 mm; 50 cm to 1 m: 10 mm; 1 m or larger: 50 mm. (Inch display:
rounded up or down to the nearest 0.25", 0.5", 0.75", 1", or 1.5").
For example, if the distance adjustment is set to 5 mm and the distance between
the registration marks is read as 312 mm, the distance is rounded down to the
nearest 5 mm and is treated as a distance of 310 mm.
1
Step
Press the
(PAUSE) key to switch to PAUSE mode.
2
Step
Press the
(NEXT) or
A U T O R E G . M A R K
3
Step
Press the
(ENTER) key to display the Auto Reg. Mark submenu, and then
press the
(NEXT) or
M A R K D I S T . A D J .
4
Step
Press the
(ENTER) key to display the registration-mark distance-adjustment
setting.
M A R K D I S T . O F F
5
Step
Press the
or
key to select "OFF," "5 mm," "10 mm," "50 mm," or "STD."
and then press the
(NEXT) or
(PREV.) key.
(NEXT) or
(PREV.) key until the following menu is displayed.
(PREV.) key until the following menu is displayed.
(ENTER) key to confirm. To cancel the selection, press the
4 – 15
(PREV.) key.

Advertisement

Table Of Contents

   Also See for GRAPHTEC CE5000-60

This manual also for:

Ce5000-120

Comments to this Manuals

Symbols: 0
Latest comments: