Download Print this page

GRAPHTEC CE6000 SERIES User Manual: Setting The Offset Angle

Graphtec ce6000 series cutting plotter.
Hide thumbs

Advertisement

7.3

Setting the Offset Angle

The CE6000 analyzes the cutting data, and controls the angle of the cutter blade tip if the change in the angles of
the corner is large.
Angle control is applied if there is larger angle change than the angle specified as reference angle.
The time to cut is shortened by setting large value for the reference angle, since it will only apply blade control
when there are angles with large angle change, hence reducing the time to make the blade control.
But, if it is set too large, there will be not enough angle control of the blade, and the cut result may differ from what
was expected. Set the reference angle in good balance.
Supplement
This setting is maintained even if the power is turned off.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the [4] key (OFFSET ANGLE).
OFFSET ANGLE setting screen is displayed.
4
Press the POSITION (
setting value.
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOLS setting screen (1/3).
6
Press the [PAUSE/MENU] key.
It will return to default screen.
) key and increase or decrease the
7-8
Supplement
Perform the settings in Normal mode.
Supplement
Setting range is from 0 to 60.
Supplement
It will return to TOOLS setting screen (1/3)
without changing the settings when you press
the POSITION ( ) key (CANCEL).

Advertisement

   Also See for GRAPHTEC CE6000 SERIES

Comments to this Manuals

Symbols: 0
Latest comments:
  • Jishad Jan 10, 2018 08:16:
    my graphtec ce 6000-60 showing an error message
    Hardware illegal code. Can you solve this
  • sina oyekunle Dec 21, 2017 02:44:
    my graphtec ce 6000-60 showing an error message: check cam_b-pcb
  • jitendra solanki Jun 14, 2017 05:31:
    i want ce6000 series user manual pdf file