GRAPHTEC CE6000 SERIES User Manual page 222

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

Symptom
• Cannot change the tool
condition.
• Tool condition changes.
• Media travels tilted.
• Changing of the hold-down
force of the push roller is not
suitable for the media.
(Only for the CE6000-120)
• It does not become specified
length. (Slight distance
error)
• "LOAD MEDIA!" is displayed
even if the media is set and
media set lever is moved up.
Possible Cause
Setting for the sorting is set to
ON.
Setting of the priority is set to
PROGRAM.
[ENTER] key is not pressed
after changing the TOOL
CONDITION.
Media is loaded tilted.
Media is slipping.
Changing of the hold-down
force of the push roller is not
suitable for the media.
Media is slipping.
Distance adjust value is not
correct.
Media is close to transparent
and media sensor makes
false recognition. (This may
happen depending on the
media.)
Media sensor malfunctions
with strong scattered
reflection.
There may be defective in the
operation of the media set
lever sensor.
Solution
Normally, use the plotter with setting
for the sorting OFF.
Change the setting of the priority to
MANUAL.
Check the TOOL CONDITION again.
Reload the media.
Perform pre feed once and make
impression to make it harder to slip.
Please set a media suitable for
changing the hold-down force.
Make the speed slower.
Increase the tool up speed.
Perform feeding.
Perform distance adjust.
Transparent media cannot be
detected. DISABLE the media sensor
and set the cut area when this kind of
media is used.
Move the position of the light source.
Make is so no direct sunlight shines.
Contact your sales representative or
the Graphtec call center.
13-4
Reference
Sorting the
P8-2
Cutting Data
Priority of
P11-3
Tool Condition Selection
(CONDITION PRIORITY)
Setting the Tool
P2-34
Condition
Loading Media
P2-6
(Paper or Making Film)
Pre Feed of Media
P2-31
(Paper or Marking Film)
Changing the
P2-21
Hold-down Force
Setting the Tool
P2-34
Condition
Pre Feed of Media
P2-31
(Paper or Marking Film)
Setting the Tool
P8-9
Up Speed
Setting the
P7-9
Distance Adjust
Enabling/
P10-4
Disabling the Media
Sensors (MEDIA SENSOR)
Setting Cutting
P4-2
Area

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents