GRAPHTEC CE6000 SERIES User Manual page 113

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
7
Press the POSITION (
setting value.
8
Confirm the setting and press the POSITION ( ) key
(PREVIOUS).
Number of copies will be selected, and it will return to COPY mode
screen.
9
Press the [3] key (COPY SPACE).
COPY SPACE setting screen is displayed.
10
Press the POSITION (
setting value.
11
Confirm the setting and press the POSITION ( ) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY MODE screen.
12
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as
specified.
) key and increase or decrease the
) key and increase or decrease the
4-12
Supplement
Number of copies can be set from 1 to 100,
as much as it can fit in the media set on the
printer.
The initial value for the number of copies is
always 1.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or
set the media that is big enough to copy.
Supplement
Copy interval can be set when MEDIA
CHANGE MODE is turned off.
Copy space can be set from 1.0 mm to 10.0
mm.
This setting is maintained even if the power
is turned off.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times
until the buffer memory is cleared. It can be
copied again after exchanging the media by
pressing [COPY] key.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents