GRAPHTEC CE6000 SERIES User Manual page 45

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

3
Position the media and the push rollers to correspond with
the width of the media.
The push rollers push down on either side of the media. Use
the grit roller position guide to make sure the push rollers are
set on top of the grit rollers.
Push roller
Media
4
Pull the media taut to make sure that there is no slack in the
conveyance path, and then raise the media set lever to lower
the push rollers.
Set the sheet media so that the paper's edges line up with
the guideline on the front side.
Line up
Grit roller
Grit roller position guide
Push roller
Media sensor
Media set lever
Supplement
The media must be at least 125 mm in length.
The media must always be positioned over
the media sensor. (For the location of media
sensor, see "1.2 Nomenclature".)
See "2.4 Aligning the Push Rollers"
about the position of the push rollers.
2-15
P.2-19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents