Setting Initial Blade Control Position Adjust - GRAPHTEC CE6000 SERIES User Manual

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

7.5

Setting Initial Blade Control Position Adjust

After turning on the power or changing pen condition settings, touch the blade to the media and adjust the blade
direction. The Initial Blade Control Position will need to be set in order to make sure the area is not damaged and
that the blade properly makes contact with the media.
Selecting [below 2 mm] will change the Initial Blade Control Position to 2 mm below the cutting start point (2 mm
from the edge of the point from which the media will be shifted.)
Selecting [Out of Range] will but the Initial Blade Control Position out of the range of the cutting area.
CAUTION
Selecting [Out of Range] and then changing the expand setting to a positive digit can damage the cutting mat.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the POSITION ( ) key.
TOOLS SETTING screen (2/3) is displayed.
Cut Start Point
(Cutting Origin Point)
Initial Blade Control Position
Setting Point
(Set as"2mm BELOW")
7-11
Cutting area
Push roller
Initial Blade Control Position
Setting Point
(Set as"OUTSIDE")
Supplement
Perform the settings in Normal mode.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents