Adjust Automatically
This section describes the operation to adjust with registration mark
scan by moving to registration mark automatically after setting the
ARMS mode and POINTS.
Operation
1
Press the [1] key (AUTO READ MARKS) in the ARMS
SETTING screen (1/4).
Following message is displayed.
2
Press the POSITION (
to the area to start scanning of the registration mark.
MARK TYPE 1
Point
4
Point 1 (point to make
origin point)
Point
3
Mode the tool inside
this area
3
Confirm the position of the tool, and if it is OK, press the
[ENTER] key (SET).
Registration marks are scanned automatically. DISTANCE entry screen
is displayed once the scanning is completed.
) key and move the tool carriage
Registration mark scan area
Point
2
100mm
Supplement
See "Adjust Manually"
moving manually to registration mark for
scanning.
Supplement
Press the [2] key (ARMS) in the MENU screen
if it is not ARMS SETTING screen.
Supplement
MARK TYPE 2
Left figure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Point
Point
2
4
Point 1 (point to make
origin point)
Point
3
Mode the tool inside
this area
Supplement
5-40
P.5-41
Scan the registration marks in accordance
with the setting of the MARK DISTANCE (see
"Setting Mark Distance"
It will return to default screen without
scanning when you press the POSITION ( )
key (CANCEL).
if you are
).
P.5-14