Running Cutting Tests; Cutting Test - GRAPHTEC CE6000 SERIES User Manual

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

2.11

Running Cutting Tests

Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts into the
media and how the corners are being cut. If the cutting results are not satisfactory, adjust the various settings and
repeat the test cutting until the optimal settings are achieved.

Cutting Test

Here, you can either cut one test pattern based on the current values, or do three tests with ±1 values added.
To make 1 cut with set value
Operation
1
Load the media for test cutting in the plotter.
2
Press the [COND/TEST] key in the default screen.
In Normal mode, CONDITION screen (1/3) is displayed.
In Simple mode, CONDITION screen (1/5) is displayed.
CONDITION screen
(Normal mode)
3
Press the POSITION ( ) key (CUT TEST).
4
Press the POSITION (
location you wish to perform the test cutting.
5
Press the [ENTER] key.
1 cut test pattern is cut.
6
Press the [ENTER] key after completion.
CONDITION screen is displayed.
7
Press the [COND/TEST] key.
It will return to default screen.
CONDITION screen
(Simple mode)
) key the tool carriage to the
2-45
Supplement
It will return to CONDITION screen by pressing
the [4] key (CANCEL).
Supplement
Pushing the [POSITION] and [FAST] keys
simultaneously will move the tool carriage
faster.
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to
cut your fingers.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents